Avaya ERS4826GTS Setup

Ethernet Switch Setup
Avaya ERS4850 Series
and ERS4850GTS-PWR+)
Firmware used: 5.8.0.1

Configuring the Switch

Assign an IP address, enable the optional web interface, and assign
QoS
1. Using a standard network switch console or "rollover" cable, connect the serial port on the
PC, or a USB-to-serial adapter, to the console port on the front of the switch.
2. Open a terminal emulator such as HyperTerminal or PuTTY and connect to the switch
using the following serial settings: 9600, N, 8, 1; no flow control.
If the switch does not respond by initiating a terminal session, try turning it off and on again.
As the switch boots up, the terminal emulator window should start displaying log
messages.
3. When the AVAYA logo appears, it will also display a status area indicating the switch
model, hardware version, firmware version, and the software version.
4. Press Ctrl+Y. A prompt showing the switch model number will appear—for example,
4850GTS-PWR+> will appear. (Other models will display accordingly; for this setup guide,
we will use the 4850GTS-PWR+ as an example.)
5. Type enable and then press Enter.
6. The prompt will change to 4850GTS-PWR+#
Type
configure terminal
and press Enter.
7. The message "Enter configuration commands, one per line. End with CNTL/Z." will appear,
followed by the configuration-mode prompt, 4850GTS-PWR+(config)#
The next step is to configure the switch's intended IP address and subnet. Type
ip address xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy
Revision 1.1—21 January 2016
(Models ERS4826GTS, ERS4826GTS-PWR+, ERS4850GTS,
Software used: v5.8.1.029
for Q-SYS