Configuring The Vlan As An Ipv6 Vlan - Avaya ERS 8800 series Configuration Manual

Basic IPv6 configuration using the ACLI
Variable definitions
Use the data in the following table to use the ipv6 interface and ipv6 interface
address commands.
address <ipv6 address>
address-type <1-2>
mtu <bytes>
multicast-routing
reachable-time <ms>
retransmit-time <ms>
vlan <vlan id>

Configuring the VLAN as an IPv6 VLAN

Configure a VLAN as an IPv6 VLAN to use IPv6 routing on the VLAN.
124 Configuration — IPv6 Routing
ipv6 interface [address-type <1-2>] [mtu <bytes>] [muticast-
routing] [reachacble-time <ms>] [retransmit-time <ms>] [vlan
<vlan id>]
Variable Value
Configures the IPv6 address and prefix length in
the format address and prefix length.
The default value is none.
1—unicast, 2—anycast.
The default value is 1—unicast.
Configures the maximum transmission unit for the
interface.
The default value is 1500.
Enables or disables MLD.
The default value is disable.
Configures the time, in milliseconds, that a
neighbor is considered reachable after receiving
a reachability confirmation.
The default value is 30000.
Configures the time, in milliseconds, between
retransmissions of Neighbor Solicitation
messages to a neighbor when resolving the
address or when probing the reachability of a
neighbor.
The default value is 1000.
Specifies the VLAN ID.
November 2010