Avaya ERS 8800 series Configuration Manual page 267

Prerequisites
Access Global configuration mode.
Procedure steps
1. Enable RSMLT-edge by using the following command: ip rsmlt edge-support
2. Clear RSMLT peer information and delete the RSMLT peer address by using the
3. Display RSMLT-edge status information by using the following command: show ip
Variable definitions
Use the data in the following table to use the no ip rsmlt peer-address command.
Variable
<vlan ID>
Configuration — IPv6 Routing
Use the no operator to disable RSMLT-edge: no ip rsmlt edge-support
following command: no ip rsmlt peer-address <vlan ID>
rsmlt edge-support
The ID of the VLAN in the range of 0 to 4094.
Configuring RSMLT-edge
Value
November 2010 267