Configuring Ospf Static Redistribution; Configuring Port-Based Ospf Neighbor Parameters - Avaya ERS 8800 series Configuration Manual

ipv6 redistribute direct enable

Configuring OSPF static redistribution

Enable or disable static redistribution to redistribute IPv6 static routes into an OSPFv3 routing
domain.
Prerequisites
You must log on to the OSPF Router Configuration mode in the ACLI.
Procedure steps
Configure OSPF static redistribution by using the following command:
ipv6 redistribute static enable

Configuring port-based OSPF neighbor parameters

Configure port-based OSPFv3 neighbor parameters for specified ports to customize your
OSPF IPv6 configuration.
Important:
Both sides of the OSPF connection must use the same authentication type and key.
Prerequisites
You must log on to the Interface Configuration mode in the ACLI.
Procedure steps
Configure port-based OSPF neighbor parameters by using the following command:
ipv6 ospf nbma-nbr <Ipv6address/prefix-len> priority <priority>
Configuration — IPv6 Routing
Configuring OSPF static redistribution
November 2010 189