Modifying Tunnel Hop Limits - Avaya ERS 8800 series Configuration Manual

Procedure steps
1. In the navigation tree, open the following folders:Configuration, IPv6.
2. Double-click Tunnel.
3. Select the tunnel to delete.
4. Click Delete.

Modifying tunnel hop limits

Modify tunnel hop limits to update hop limit values on previously configured tunnels.
Procedure steps
1. In the navigation tree, open the following folders:Configuration, IPv6.
2. Double-click Tunnel.
3. Click the Tunnel Interface tab.
4. In the row for the tunnel to configure, double-click the HopLimit column to modify
5. Click Apply.
Variable definitions
Use the data in the following table to use the Tunnel Interface tab.
Variable
Index
EncapsMethod
HopLimit
Security
TOS
Configuration — IPv6 Routing
the displayed information as required.
Identifies the tunnel interface internally. The value is derived
from the tunnel ID.
Displays the tunnel mode: IPv6 for manually configured tunnels
and 6to4 for automatically configured tunnels.
Configures the maximum number of hops in the tunnel.
The default value is 255.
Indicates the type of security on the tunnel interface.
Displays the method used to configure the high 6 bits (the
differentiated services codepoint) of the IPv4 type of service
(TOS) or IPv6 traffic class in the outer IP header. A value of -1
indicates that the bits are copied from the payload header. A
value of -2 indicates that a traffic conditioner is invoked and
more information can be available in a traffic conditioner MIB
module. A value from 0 to 63 indicates that the bit field is
configured to the indicated value.
Modifying tunnel hop limits
Value
November 2010 273