Cas Files; Dial Plan File; Creating A Dial Plan File - AudioCodes Mediant 3000 User Manual

User's Manual

Coders: G.711 A-law or G.711 µ-law (and other coders)

Rate: 8 kHz

Resolution: 8-bit

Channels: mono
The prerecorded tones are played repeatedly. This allows you to record only part of the
tone and then play the tone for the full duration. For example, if a tone has a cadence of 2
seconds on and 4 seconds off, the recorded file should contain only these 6 seconds. The
device repeatedly plays this cadence for the configured duration. Similarly, a continuous
tone can be played by repeating only part of it.
Once created, you need to install the PRT file on the device. This can be done using
AudioCodes' AcBootP utility or the Web interface (see ''Loading Auxiliary Files'' on page
677).

44.1.5 CAS Files

The CAS Auxiliary files contain the CAS Protocol definitions that are used for CAS-
terminated trunks. You can use the supplied files or construct your own files. Up to eight
files can be loaded to the device. Different files can be assigned to different trunks
(CASTableIndex_x) and different CAS tables can be assigned to different B-channels
(CASChannelIndex).
The CAS files can be loaded to the device using the Web interface or ini file (see ''Loading
Auxiliary Files'' on page 677).

44.1.6 Dial Plan File

The Dial Plan file can be used for various digit mapping features, as described in this
section.
Note:
IP address using the Dial Plan file is for backward compatibility purposes only. For the
new method, see Configuring Dial Plans on page 633.

44.1.6.1 Creating a Dial Plan File

Note:
IP address using the Dial Plan file is for backward compatibility purposes only. For the
new method, see Configuring Dial Plans on page 633.
The Dial Plan file is a text-based file that can contain up to 8 Dial Plans (Dial Plan indices)
and up to 8,000 rules (lines). The general syntax rules for the Dial Plan file are as follows
(syntax specific to the feature is described in the respective section):

Each Dial Plan index must begin with a Dial Plan name enclosed in square brackets
"[...]" on a new line.

Each line under the Dial Plan index defines a rule.

Empty lines are ignored.
Version 7.0
For the SBC application, the method described in this section for obtaining an
For the SBC application, the method described in this section for obtaining an
683
44. Software Upgrade
Mediant 3000