Cas Parameters - AudioCodes Mediant 3000 User Manual

Parameter
[TMReferenceValidationTime]
58.10.6.3

CAS Parameters

The Common Channel Associated (CAS) parameters are described in the table below.
Parameter
CAS Transport Type
[CASTransportType]
[CASAddressingDelimiters]
[CASDelimitersPaddingUsage]
CAS Table per Trunk
[CASTableIndex_x]
User's Manual
resolution is 1 minute.
Note: The parameter is applicable only for External timing (i.e.,
BITS) and Line timing references (refer to the parameter TMMode).
Table 58-56: CAS Parameters
Determines the ABCD signaling transport type over IP.

[0] CAS Events Only = (Default) Disable CAS relay.

[1] CAS RFC2833 Relay = Enable CAS relay mode using RFC
2833.
The CAS relay mode can be used with the TDM tunneling feature
to enable tunneling over IP for both voice and CAS signaling
bearers.
Enables the addition of delimiters to the received address or
received ANI digits string.

[0] = (default) Disable. The address and ANI strings remain
without delimiters.

[1] = Enable. Delimiters such as '*', '#', and 'ST' are added to the
received address or received ANI digits string.
Defines the digits string delimiter padding usage per trunk.

[0] = (Default) Default address string padding: '*XXX#' (where
XXX is the digit string that begins with '*' and ends with '#', when
using padding).

[1] = Special use of asterisks delimiters: '*XXX*YYY*' (where
XXX is the address, YYY is the source phone number, and '*' is
the only delimiter padding).
Note: For the parameter to take effect, a device reset is required.
Defines the CAS protocol per trunk from a list of CAS protocols
defined by the parameter CASFileName_x.
For example, the below configuration specifies Trunks 0 and 1 to
use the E&M Winkstart CAS (E_M_WinkTable.dat) protocol, and
Trunks 2 and 3 to use the E&M Immediate Start CAS
(E_M_ImmediateTable.dat) protocol:
CASFileName_0 = 'E_M_WinkTable.dat'
CASFileName_1 = 'E_M_ImmediateTable.dat'
CASTableIndex_0 = 0
CASTableIndex_1 = 0
CASTableIndex_2 = 1
CASTableIndex_3 = 1
Notes:

You can define CAS tables per B-channel using the parameter
CASChannelIndex.

The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
972
Description
Description
Document #: LTRT-89730
Mediant 3000