Automatic Update Parameters - AudioCodes Mediant 3000 User Manual

Parameter
[SaveConfiguration]
Auxiliary and Configuration File Name Parameters
Call Progress Tones File
[CallProgressTonesFilenam
e]
Prerecorded Tones File
[PrerecordedTonesFileNam
e]
CAS File
[CASFileName_x]
Dial Plan
[CasTrunkDialPlanName_x]
Dial Plan File
[DialPlanFileName]
[UserInfoFileName]

58.1.8 Automatic Update Parameters

The automatic update of software and configuration files parameters are described in the
table below.
Note:
User's Manual
Note: The parameter is applicable only for automatic HTTP update or
Web ini file upload (not applicable if the ini file is loaded using BootP).
Determines if the device's configuration (parameters and files) is saved
to flash (non-volatile memory).

[0] = Configuration isn't saved to flash memory.

[1] = (Default) Configuration is saved to flash memory.
Defines the name of the file containing the Call Progress Tones
definitions.
For the ini file, the name must be enclosed by single apostrophes, for
example, 'cpt_us.dat'.
For more information on how to create and load this file, refer to
DConvert Utility User's Guide.
Note: For the parameter to take effect, a device reset is required.
Defines the name of the file containing the Prerecorded Tones.
Note: For the parameter to take effect, a device reset is required.
Defines the CAS file name (e.g., 'E_M_WinkTable.dat'), which defines
the CAS protocol (where x denotes the CAS file ID 0 to 7). It is
possible to define up to eight different CAS files by repeating the
parameter. Each CAS file can be associated with one or more of the
device's trunks, using the parameter CASTableIndex or it can be
associated per B-channel using the parameter CASChannelIndex.
For the ini file, the name must be enclosed by single apostrophes, for
example, 'cas_us.dat'.
Note: For the parameter to take effect, a device reset is required.
Defines the Dial Plan name (up to 11-character strings) per trunk.
For the ini file, the name must be enclosed by single apostrophes, for
example, 'dial_plan_2.dat'.
Note: The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
Defines the name of the Dial Plan file. This file should be created using
AudioCodes DConvert utility (refer to DConvert Utility User's Guide).
For the ini file, the name must be enclosed by single apostrophes, for
example, 'dial_plan.dat'.
Defines the name of the file containing the User Information data.
For the ini file, the name must be enclosed by single apostrophes, for
example, 'userinfo_us.dat'.
Auxiliary file upload through TFTP is not supported by HA mode.
Description
840
Mediant 3000
Document #: LTRT-89730