Tone Parameters; Telephony Tone Parameters - AudioCodes Mediant 3000 User Manual

User's Manual
Parameter
Disconnect Call on Busy
Tone Detection (CAS)
[DisconnectOnBusyTone]

58.10.9 Tone Parameters

This subsection describes the device's tone parameters.
58.10.9.1

Telephony Tone Parameters

The telephony tone parameters are described in the table below.
Parameter
Dial Tone Duration
[TimeForDialTone]
Reorder Tone Duration
[TimeForReorderTone]
Cut Through Reorder Tone
Duration
[CutThroughTimeForReOrderT
one]
Play Busy Tone to Tel
Version 7.0

For IP-to-CAS calls, detection of busy, reorder, or SIT tones
disconnect the calls in any call state.
Determines whether a call is disconnected upon detection of a busy tone.

[0] Disable = Call is not disconnected upon detection of a busy tone.

[1] Enable = (Default) Call is released upon detection of busy or
reorder (fast busy) tone.
Notes:

The parameter is applicable only to CAS.

The parameter can also be configured in a Tel Profile.
Table 58-62: Tone Parameters
Defines the duration (in seconds) that the dial tone is played to an
ISDN terminal.
The parameter is applicable for overlap dialing when
ISDNInCallsBehavior is set to 65536. The dial tone is played if the
ISDN Setup message doesn't include the called number.
The valid range is 0 to 60. The default is 5.
Defines the duration (in seconds) that the CAS device plays a busy
or reorder tone before releasing the line.
The valid range is 0 to 15. The default is 10 seconds. Note that the
Web interface denotes the default value as a string value of "255".
Notes:

The selected busy or reorder tone is according to the SIP
release cause code received from IP.

The parameter is also applicable for ISDN when the
PlayBusyTone2ISDN parameter is set to 2.

The parameter can also be configured for a Tel Profile (in the
Tel Profile table).
Defines the duration (in seconds) of the reorder tone played to the
Tel side after the IP call party releases the call, for the Cut-Through
feature. After the tone stops playing, an incoming call is
immediately answered if the PSTN is connected.
The valid values are 0 to 30. The default is 0 (i.e., no reorder tone
is played).
Note: To enable the Cut-Through feature, use the
DigitalCutThrough (for CAS channels) parameter.
Enables the device to play a busy or reorder tone to the PSTN after
1003
58. Configuration Parameters Reference
Description
Description
Mediant 3000