AudioCodes Mediant 3000 User Manual page 994

Parameter
[SendISDNServiceAfterR
estart]
[SupportRedirectInFacility
]
[CallReroutingMode]
[EnableCIC]
AoC Support
[EnableAOC]
Add IE in SETUP
[AddIEinSetup]
User's Manual
device reset. The messsage (transmitted on the trunk's D-channel)
indicates the availability of the trunk's B-channels (i.e., trunk in service).

[0] = Disable (default)

[0] = Enable
Determines whether the Redirect Number is retrieved from the Facility IE.

[0] = (Default) Not supported.

[1] = Supports partial retrieval of Redirect Number (number only) from
the Facility IE in ISDN Setup messages. This is applicable to Redirect
Number according to ECMA-173 Call Diversion Supplementary
Services.
Note: To enable this feature, the parameter
ISDNDuplicateQ931BuffMode must be set to 1.
Determines whether ISDN call rerouting (call forward) is performed by the
PSTN instead of by the SIP side. This call forwarding is based on Call
Deflection for Euro ISDN (ETS-300-207-1) and QSIG (ETSI TS 102 393).

[0] Disable (default).

[1] Enable = Enables ISDN call rerouting. When the device sends the
INVITE message to the remote SIP entity and receives a SIP 302
response with a Contact header containing a URI host name that is
the same as the device's IP address, the device sends a Facility
message with a Call Rerouting invoke method to the ISDN and waits
for the PSTN side to disconnect the call.
Note: When the parameter is enabled, ensure that you configure in the IP
to Trunk Group Routing table (PSTNPrefix ini file parameter) a rule to
route the redirected call (using the user part from the 302 Contact
header) to the same Trunk Group from where the incoming Tel-to-IP call
was received.
Enables the relay of the Carrier Identification Code (CIC) to the ISDN.

[0] = (Default) Disabled - CIC is not relayed to the ISDN.

[1] = Enabled - CIC (received in the INVITE Request-URI) is relayed
to the ISDN in the Transit Network Selection (TNS) IE of the Setup
message. For example: INVITE sip:555666;cic=2345@100.2.3.4
sip/2.0.
Notes:

This feature is supported only for SIP-to-ISDN calls.

The parameter AddCicAsPrefix can be used to add the CIC as a prefix
to the destination phone number for routing IP-to-Tel calls.
Enables the interworking of ISDN Advice of Charge (AOC) messages to
SIP.

[0] Disable (default)

[1] Enable
For more information on AOC, see ''Advice of Charge Services for Euro
ISDN'' on page 537.
Global parameter that defines an optional Information Element (IE) data
(in hex format) to add to ISDN Setup messages. You can also configure
this functionality per specific calls, using IP Profiles
(IpProfile_AddIEInSetup). For a detailed description of the parameter and
for configuring this functionality in the IP Profile table, see ''Configuring IP
Profiles'' on page 391.
Note: If this functionality is configured for a specific IP Profile, the settings
994
Description
Document #: LTRT-89730
Mediant 3000