AudioCodes Mediant 3000 User Manual page 949

User's Manual
Parameter
MWI Off Digit Pattern
[MWIOffCode]
MWI On Digit Pattern
[MWIOnCode]
MWI Suffix Pattern
[MWISuffixCode]
MWI Source Number
[MWISourceNumber]
[MWISubscribeIPGroupID]
[NotificationIPGroupID]
[MWIQsigMsgCentreldIDP
artyNumber]
Digit Patterns The following digit pattern parameters apply only to voice mail applications that use
the DTMF communication method. For the available pattern syntaxes, refer to the CPE Configuration
Guide for Voice Mail.
Version 7.0
Defines the digit code used by the device to notify the PBX that there
are no messages waiting for a specific extension. This code is added as
prefix to the dialed number.
The valid range is a 25-character string.
Defines the digit code used by the device to notify the PBX of messages
waiting for a specific extension. This code is added as prefix to the
dialed number.
The valid range is a 25-character string.
Defines the digit code used by the device as a suffix for 'MWI On Digit
Pattern' and 'MWI Off Digit Pattern'. This suffix is added to the
generated DTMF string after the extension number.
The valid range is a 25-character string.
Defines the calling party's phone number used in the Q.931 MWI Setup
message to PSTN. If not configured, the channel's phone number is
used as the calling number.
Defines the IP Group ID used when subscribing to an MWI server. The
'The SIP Group Name' field value of the IP Group table is used as the
Request-URI host name in the outgoing MWI SIP SUBSCRIBE
message. The request is sent to the IP address defined for the Proxy
Set that is associated with the IP Group. The Proxy Set's capabilities
such as proxy redundancy and load balancing are also applied to the
message.
For example, if the 'SIP Group Name' field of the IP Group is set to
"company.com", the device sends the following SUBSCRIBE message:
SUBSCRIBE sip:company.com...
Instead of:
SUBSCRIBE sip:10.33.10.10...
Note: If the parameter is not configured, the MWI SUBSCRIBE
message is sent to the MWI server as defined by the MWIServerIP
parameter.
Defines the IP Group ID to which the device sends SIP NOTIFY MWI
messages.
Notes:

This is used for MWI Interrogation. For more information on the
interworking of QSIG MWI to IP, see Message Waiting Indication on
page 531.

To determine the handling method of MWI Interrogation messages,
use the TrunkGroupSettings_MWIInterrogationType, parameter (in
the Trunk Group Settings table).
Defines the Message Centred ID party number used for QSIG MWI
messages. If not configured (default), the parameter is not included in
MWI (activate and deactivate) QSIG messages.
The valid value is a string.
949
58. Configuration Parameters Reference
Description
Mediant 3000