Ip Media Parameters - AudioCodes Mediant 3000 User Manual

Parameter
[SASRegistrationManipulat
ion]
SAS IP-to-IP Routing Table
[IP2IPRouting]

58.13 IP Media Parameters

The IP media parameters are described in the table below.
Parameter
IPMedia Detectors
[EnableDSPIPMDetectors]
Number of Media Channels
media-channels
[MediaChannels]
User's Manual
format of The table is as follows:
[SASRegistrationManipulation]
FORMAT SASRegistrationManipulation_Index =
SASRegistrationManipulation_RemoveFromRight,
SASRegistrationManipulation_LeaveFromRight;
[\SASRegistrationManipulation]
For example, the manipulation rule below routes an INVITE with
Request-URI header "sip:7184002@10.33.4.226" to user
"4002@10.33.4.226" (i.e., keep only four digits from right of user part):
SASRegistrationManipulation 0 = 0, 4;
Defines the IP-to-IP Routing table for SAS routing rules. The format of
the ini file table parameter is as follows:
[IP2IPRouting]
FORMAT IP2IPRouting_Index = IP2IPRouting_SrcIPGroupName,
IP2IPRouting_SrcUsernamePrefix, IP2IPRouting_SrcHost,
IP2IPRouting_DestUsernamePrefix, IP2IPRouting_DestHost,
IP2IPRouting_DestType, IP2IPRouting_DestIPGroupName,
IP2IPRouting_DestSRDID, IP2IPRouting_DestAddress,
IP2IPRouting_DestPort, IP2IPRouting_DestTransportType,
IP2IPRouting_AltRouteOptions;
[\IP2IPRouting]
For example:
IP2IPRouting 1 = -1, *, *, *, *, 0, -1, -1, , 0, -1, 0;
Table 58-72: IP Media Parameters
Enables the device's DSP detectors for detection features such as
AMD.

[0] Disable (default)

[1] Enable
Notes:

For the parameter to take effect, a device reset is required.

The DSP Detectors feature is available only if the device is installed
with a Software License Key that includes this feature. For installing
a Software License Key, see ''Software License Key'' on page 697.

When enabled (1), the number of available channels is reduced.
Defines the maximum number of DSP channels allocated for various
functionalities such as transcoding, .
The default is 0.
Notes:

For the parameter to take effect, a device reset is required.

The SBC application does not require DSP channels. The SBC
application uses DSP channels only if media transcoding is needed,
1048
Description
Description
Document #: LTRT-89730
Mediant 3000