AudioCodes Mediant 3000 User Manual page 664


To disable Physical Network Separation and configure the device for multiple
interfaces using the ini file:
1. Prepare an ini file with the parameter EnableNetworkPhysicalSeparation set to 0 to
disable Physical Network Separation mode, and parameters configuring the OAMP,
Control, and Media interfaces using the table ini file parameter InterfaceTable (as
described in Using the ini File).
2. Insert a single RTM-8410 blade in the Mediant 3000 chassis (each blade is configured
separately).
3. Ensure that the Ethernet cable is connected to the Ethernet port for the OAMP
interface on the PEM (i.e., not to the RTM-8410 blade).
4. Load the ini file prepared in Step 1, using the Web interface (see ''Backing Up and
Loading Configuration File'' on page 707). Alternatively, you can use BootP/DHCP to
load the ini file.
5. Save and reset the device, using the Web interface (see ''Resetting the Device'' on
page 669).
6. Verify that the Syslog displays the following message: "Updating Flash to work in Non
Network Separation Mode in the next Boot".
7. If the Mediant 3000 is in High Availability (HA) mode, remove the blade that you
configured above, insert the second blade, and then repeat steps 1 through 6 for the
second blade (using the identical ini file).
8. Insert the blade (or both blades if in HA mode) in the chassis, and then connect an
Ethernet cable to each RTM-8410. The OAMP, Media, and Control network interfaces
are all now through the Ethernet port on the RTM-8410.
User's Manual 664
Mediant 3000
Document #: LTRT-89730