Answer And Disconnect Supervision Parameters - AudioCodes Mediant 3000 User Manual
Media gateway & enterprise session border
controller (e-sbc)
Hide thumbs
Also See for Mediant 3000:
- User manual (984 pages) ,
- Installation manual (90 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
Parameter
Release Cause Mapping from ISDN to SIP Table
Release Cause Mapping
Table
[CauseMapISDN2SIP]
Release Cause Mapping from SIP to ISDN Table
Release Cause Mapping
Table
[CauseMapSIP2ISDN]
ISDN-to-ISDN Release Cause Code Conversion Table
Release Cause ISDN >
ISDN
[CauseMapIsdn2Isdn]
58.10.8 Answer and Disconnect Supervision Parameters
The answer and disconnect supervision parameters are described in the table below.
Parameter
Wait before PSTN
Release-Ack
wait-befor-pstn-rel-ack
[TimeToWaitForPstnRele
aseAck]
Answer Supervision
[EnableVoiceDetection]
User's Manual
Content-Length: 17
event flashhook
Note: The parameter is applicable only to T1 CAS protocols.
This table parameter maps ISDN Q.850 Release Causes to SIP
responses. The format of the ini file table parameter is as follows:
[CauseMapISDN2SIP]
FORMAT CauseMapISDN2SIP_Index =
CauseMapISDN2SIP_IsdnReleaseCause,
CauseMapISDN2SIP_SipResponse;
[\CauseMapISDN2SIP]
This table parameter maps SIP responses to Q.850 Release Causes.
The format of the ini file table parameter is as follows:
[CauseMapSIP2ISDN]
FORMAT CauseMapSIP2ISDN_Index =
CauseMapSIP2ISDN_SipResponse,
CauseMapSIP2ISDN_IsdnReleaseCause;
[\CauseMapSIP2ISDN]
Defines ISDN-to-ISDN release cause code mapping rules.
The format of the ini file table parameter is as follows:
[ CauseMapIsdn2Isdn ]
FORMAT CauseMapIsdn2Isdn_Index =
CauseMapIsdn2Isdn_OrigIsdnReleaseCause,
CauseMapIsdn2Isdn_MapIsdnReleaseCause;
[ \CauseMapSip2Isdn ]
For a detailed description of this table, see ''Configuring ISDN-to-ISDN
Release Cause Mapping'' on page 491.
Table 58-61: Answer and Disconnect Parameters
Defines a timeout (in milliseconds) that the device waits for the receipt of
an ISDN Q.931 Release message from the PSTN side before releasing
the channel. The Release ACK is typically sent by the PSTN in response
to the device's Disconnect message to end the call. If the timeout expires
and a Release message has not yet been received, the device releases
the call channel.
The valid value is 1 to 360,000. The default is 6,000.
Enables the sending of SIP 200 OK upon detection of speech, fax, or
modem.
[1] Yes = The device sends a SIP 200 OK (in response to an INVITE
message) when speech, fax, or modem is detected.
Description
Description
1000
Mediant 3000
Document #: LTRT-89730
Advertisement
Table of Contents
