AudioCodes Mediant 3000 User Manual page 389

User's Manual
Table 20-4: Tel Profile Table Parameters and Corresponding Global Parameters
Tel Profile Parameter
Common
Index
[TelProfile_Index]
Profile Name
[TelProfile_ProfileName]
Profile Preference
[TelProfile_TelPreference]
Fax Signaling Method
[TelProfile_IsFaxUsed]
Enable Digit Delivery
[TelProfile_EnableDigitDelivery]
Time For Reorder Tone
[TelProfile_TimeForReorderTone]
Disconnect Call on Detection of Busy Tone
[TelProfile_DisconnectOnBusyTone]
Enable Voice Mail Delay
[TelProfile_EnableVoiceMailDelay]
Dial Plan Index
[TelProfile_DialPlanIndex]
Swap Tel To IP Phone Numbers
[TelProfile_SwapTelToIpPhoneNumbers]
Digital Cut Through
[TelProfile_DigitalCutThrough]
Call Priority Mode
[TelProfile_CallPriorityMode]
IP Related
Version 7.0
Global Parameter
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines an arbitrary name to easily identify the row.
The valid value is a string of up to 20 characters.
Defines the priority of the Tel Profile, where 1 is the lowest priority and 20
the highest priority.
Notes:
1. If both the IP Profile and Tel Profile apply to the same call, the coders and
common parameters of the Preferred profile are applied to the call.
2. If the Preference of the Tel Profile and IP Profile are identical, the Tel
Profile parameters are applied.
3. If the coder lists of both the IP Profile and Tel Profile apply to the same
call, only the coders common to both are used. The order of the coders is
determined by the preference.
IsFaxUsed
EnableDigitDelivery
TimeForReorderTone
DisconnectOnBusyTone
VoiceMailInterface
This is useful for disabling voice mail services per Trunk Group to eliminate
the phenomenon of call delay on Trunks that do not implement voice mail
when voice mail is enabled using the global parameter.
DialPlanIndex
SwapTEl2IPCalled&CallingNumbers
DigitalCutThrough
CallPriorityMode
389
20. Coders and Profiles
Mediant 3000