AudioCodes Mediant 3000 User Manual page 822

Media gateway & enterprise session border controller (e-sbc)

Hide thumbs Also See for Mediant 3000:

Table of Contents

Tel-to-IP Routing table configuration:

Batch Test Call Scenario: This example describes the configuration of a batch test

call setup for scheduled and continuous call testing of multiple endpoints. The test call

is done between two AudioCodes devices - Device A and Device B - with simulated

test endpoints. This eliminates the need for phone users, who would otherwise need

to answer and end calls many times for batch testing. The calls are initiated from

Device A, where Device B serves as the remote answering endpoint.

Test Call table configuration at Device A:

Test Call table configuration at Device B:

User's Manual

SIP Interface: SIPInterface_0

Called URI: 201@10.30.40.1

Call Party: Caller

Destination Phone Prefix: 201 (i.e., the Called URI user-part)

Source Phone Prefix: 101 (i.e., the Endpoint URI user-part)

Destination IP Address: 10.30.40.1

Figure 56-9: Batch Test Call Example

Endpoint URI: "101"

Called URI: "201"

Route By: Dest Address

Destination Address: "10.13.4.12"

SIP Interface: SIPInterface_0

Call Party: Caller

Maximum Channels for Session: "3" (configures three endpoints - "101",

"102" and "103)

Call Duration: "5" (seconds)

Calls per Sec: "1"

Test Mode: Continuous

Test Duration: "3" (minutes)

Schedule Interval: "180" (minutes)

Endpoint URI: "201"

Maximum Channels for Session: "3" (configures three endpoints - "201",

"202" and "203)

Mediant 3000

Document #: LTRT-89730