Configuring Ldap Server Groups - AudioCodes Mediant 3000 User Manual

Before you can configure LDAP-based login authentication, you must enable this type of
LDAP service, as described in the following procedure.

To enable LDAP-based login authentication:
1. Open the Authentication Settings page (Configuration tab > System menu >
Management > Authentication Settings).
Figure 16-6: Authentication Settings Page - Enabling LDAP-based Login
2. Under LDAP Settings, from the 'Use LDAP for Web/Telnet Login' drop-down list,
select Enable.
3. Click Submit, and then reset the device with a burn-to-flash for your settings to take
effect.

16.3.3 Configuring LDAP Server Groups

The LDAP Server Groups table lets you configure up to 33 LDAP Server Groups. An LDAP
Server Group is a logical configuration entity that contains up to two LDAP servers. LDAP
servers are assigned to LDAP Server Groups in the LDAP Configuration table (see
''Configuring LDAP Servers'' on page 250). To use a configured LDAP server, you must
assign it to an LDAP Server Group.
To use an LDAP server for call routing, you must configure its' LDAP Server Group as
"Control" type, and then assign the LDAP Server Group to a Routing Policy. The Routing
Policy in turn, needs to be assigned to the relevant routing rule(s). A Routing Policy can be
assigned only one LDAP Server Group. Therefore, for multi-tenant deployments where
multiple Routing Policies are employed, each tenant can be assigned a specific LDAP
Server Group through its unique Routing Policy.
To use an LDAP server for management user login authentication and authorization, you
must configure its' LDAP Server Group as "Management" type. Additional LDAP-based
management parameters need to be configured, as described in ''Enabling LDAP-based
Web/CLI User Login Authentication and Authorization'' on page 247 and ''Configuring
LDAP Servers'' on page 250.
The following procedure describes how to configure an LDAP Server Group through the
Web interface. You can also configure it through ini file (LDAPServersGroup).

To configure an LDAP Server Group:
1. Open the LDAP Server Groups table (Configuration tab > VoIP menu > Services >
LDAP > LDAP Server Groups).
User's Manual 248
Mediant 3000
Document #: LTRT-89730