AudioCodes Mediant 3000 User Manual page 995

User's Manual
Parameter
Trunk Groups to Send IE
[SendIEonTG]
Enable User-to-User IE
for Tel to IP
[EnableUUITel2IP]
Enable User-to-User IE
for IP to Tel
[EnableUUIIP2Tel]
[Enable911LocationIdIP2
Tel]
Version 7.0
of this global parameter is ignored for calls associated with the IP Profile.
Defines Trunk Group IDs (up to 50 characters) from where the optional
ISDN IE (defined by the parameter AddIEinSetup) is sent. For example:
'1,2,4,10,12,6'.
Notes:

You can configure different IE data for Trunk Groups by defining the
parameter for different IP Profile IDs (using the parameter IPProfile),
and then assigning the required IP Profile ID in the IP to Trunk Group
Routing table (PSTNPrefix).

When IP Profiles are used for configuring different IE data for Trunk
Groups, the parameter is ignored.
Enables transfer of User-to-User (UU) IE from ISDN PRI to SIP.

[0] Disable (default)

[1] Enable
The device supports the following ISDN PRI-to-SIP interworking: Setup to
SIP INVITE, Connect to SIP 200 OK, User Information to SIP INFO,
Alerting to SIP 18x response, and Disconnect to SIP BYE response
messages.
Note: The interworking of ISDN User-to-User IE to SIP INFO is
applicable only to the Euro ISDN, QSIG, and 4ESS PRI variants.
Enables interworking of SIP user-to-user information (UUI) to User-to-
User IE in ISDN Q.931 messages.

[0] Disable = (Default) Received UUI is not sent in ISDN message.

[1] Enable = The device interworks UUI from SIP to ISDN messages.
The device supports the following SIP-to-ISDN interworking of UUI:

SIP INVITE to Q.931 Setup

SIP REFER to Q.931 Setup

SIP 200 OK to Q.931 Connect

SIP INFO to Q.931 User Information

SIP 18x to Q.931 Alerting

SIP BYE to Q.931 Disconnect
Notes:

The interworking of ISDN User-to-User IE to SIP INFO is applicable
only to the Euro ISDN, QSIG, and 4ESS PRI variants.

To interwork the UUIE header from SIP-to-ISDN messages with the
4ESS ISDN variant, the ISDNGeneralCCBehavior parameter must be
set to 16384.
Enables interworking of Emergency Location Identification from SIP to
PRI.

[0] = Disabled (default)

[1] = Enabled
When enabled, the From header received in the SIP INVITE is translated
into the following ISDN IE's:

Emergency Call Control.

Generic Information - to carry the Location Identification Number
information.

Generic Information - to carry the Calling Geodetic Location
information.
995
58. Configuration Parameters Reference
Description
Mediant 3000