AudioCodes Mediant 3000 User Manual page 1012

Parameter
Use Display Name as Source
Number
[UseDisplayNameAsSourceN
umber]
ENUM Resolution
[EnumService]
Use Routing Table for Host
Names and Profiles
[AlwaysUseRouteTable]
Tel to IP Routing Mode
[RouteModeTel2IP]
Tel-to-IP Routing table
User's Manual
done before regular calling number manipulation.
Determines the use of Source Number and Display Name for IP-to-
Tel calls.

[0] No = (Default) If IP Display Name is received, the IP Source
Number is used as the Tel Source Number and the IP Display
Name is used as the Tel Display Name. If no Display Name is
received from IP, the Tel Display Name remains empty.

[1] Yes = If an IP Display Name is received, it is used as the Tel
Source Number and also as the Tel Display Name, and
Presentation is set to Allowed (0). If no Display Name is received
from IP, the IP Source Number is used as the Tel Source Number
and Presentation is set to Restricted (1).
For example: When 'From: 100 <sip:200@201.202.203.204>' is
received, the outgoing Source Number and Display Name are set to
'100' and the Presentation is set to Allowed (0).
When 'From: <sip:100@101.102.103.104>' is received, the outgoing
Source Number is set to '100' and the Presentation is set to
Restricted (1).
Defines the ENUM service for translating telephone numbers to IP
addresses or domain names (FQDN), for example, e164.arpa,
e164.customer.net, or NRENum.net.
The valid value is a string of up to 50 characters. The default is
"e164.arpa".
Note: ENUM-based routing is configured in the Tel-to-IP Routing
table using the "ENUM" string value as the destination address to
denote the parameter's value.
Determines whether to use the device's routing table to obtain the
URI host name and optionally, an IP profile (per call) even if a Proxy
server is used.

[0] Disable = (Default) Don't use the Tel-to-IP Routing table.

[1] Enable = Use the Tel-to-IP Routing table.
Notes:

The parameter appears only if the 'Use Default Proxy' parameter
is enabled.

The domain name is used instead of a Proxy name or IP address
in the INVITE SIP URI.
Determines whether to route Tel calls to an IP destination before or
after manipulation of the destination number. This applies to Tel-to-IP
routing rules configured in the Tel-to-IP Routing table.

[0] Route calls before manipulation = Calls are routed before the
number manipulation rules are applied (default).

[1] Route calls after manipulation = Calls are routed after the
number manipulation rules are applied.
Notes:

The parameter is not applicable if outbound proxy routing is used.

For number manipulation, see ''Configuring Source/Destination
Number Manipulation'' on page 469.

For configuring Tel-to-IP routing rules, see ''Configuring Tel-to-IP
Routing Rules'' on page 496.
1012
Description
Document #: LTRT-89730
Mediant 3000