Ocsp Parameters - AudioCodes Mediant 3000 User Manual

Parameter
IPSec Proposal Table
IP Security Proposal
Table
[IPSecProposalTable]

58.4.8 OCSP Parameters

The Online Certificate Status Protocol (OCSP) parameters are described in the table
below.
Parameter
Enable OCSP Server
[OCSPEnable]
Primary Server IP
[OCSPServerIP]
Secondary Server IP
User's Manual
IPsecSATable_SourcePort, IPsecSATable_DestPort,
IPsecSATable_Protocol, IPsecSATable_Phase1SaLifetimeInSec,
IPsecSATable_Phase2SaLifetimeInSec,
IPsecSATable_Phase2SaLifetimeInKB, IPsecSATable_DPDmode,
IPsecSATable_IPsecMode, IPsecSATable_RemoteTunnelAddress,
IPsecSATable_RemoteSubnetIPAddress,
IPsecSATable_RemoteSubnetPrefixLength,
IPsecSATable_InterfaceName;
[ \IPsecSATable ]
Note: For a detailed description of the table, see ''Configuring IP Security
Associations Table'' on page 188.
The table defines up to four IKE proposal settings, where each proposal
defines an encryption algorithm, an authentication algorithm, and a Diffie-
Hellman group identifier.
[ IPsecProposalTable ]
FORMAT IPsecProposalTable_Index =
IPsecProposalTable_EncryptionAlgorithm,
IPsecProposalTable_AuthenticationAlgorithm,
IPsecProposalTable_DHGroup;
[ \IPsecProposalTable ]
For example:
IPsecProposalTable 0 = 3, 2, 1;
IPsecProposalTable 1 = 2, 2, 1;
In the example above, two proposals are defined:

Proposal 0: AES, SHA1, DH group 2

Proposal 1: 3DES, SHA1, DH group 2
Note: For a detailed description of the table, see ''Configuring IP Security
Proposal Table'' on page 187.
Table 58-31: OCSP Parameters
Enables or disables certificate checking using OCSP.

[0] Disable (default)

[1] Enable
For a description of OCSP, see Configuring Certificate Revocation
Checking (OCSP).
Defines the IP address of the OCSP server.
The default IP address is 0.0.0.0.
Defines the IP address (in dotted-decimal notation) of the secondary
OCSP server (optional).
876
Description
Description
Document #: LTRT-89730
Mediant 3000