Viewing Ip Connectivity - AudioCodes Mediant 3000 User Manual

51.10 Viewing IP Connectivity

The IP Connectivity page displays on-line, read-only network diagnostic connectivity
information on all destination IP addresses configured in the Tel-to-IP Routing table (see
''Configuring Tel-to-IP Routing Rules'' on page 496).
Note:
reset if two minutes elapse without a call to that destination.

To view IP connectivity information:
1. In the Routing General Parameters page, set the 'Enable Alt Routing Tel to IP'
parameter (AltRoutingTel2IPMode) to Enable or Status Only (see ''Configuring
General Routing Parameters'' on page 495).
2. Open the IP Connectivity page (Status & Diagnostics tab > VoIP Status menu > IP
Connectivity).
Column Name
IP Address The IP address can be one of the following:


Host Name Host name (or IP address) as configured in the Tel-to-IP Routing table.
Connectivity The method according to which the destination IP address is queried
Method periodically (ICMP ping or SIP OPTIONS request).
Connectivity
The status of the IP address' connectivity according to the method in the
Status 'Connectivity Method' field.





User's Manual
he information in columns 'Quality Status' and 'Quality Info' (per IP address) is
Figure 51-9: IP Connectivity Page
Table 51-5: IP Connectivity Parameters
IP address defined as the destination IP address in the Tel-to-IP Routing
table.
IP address resolved from the host name defined as the destination IP
address in the Tel-to-IP Routing table.
OK = Remote side responds to periodic connectivity queries.
Lost = Remote side didn't respond for a short period.
Fail = Remote side doesn't respond.
Init = Connectivity queries not started (e.g., IP address not resolved).
Disable = The connectivity option is disabled, i.e., parameter 'Alt Routing Tel
Description
754
Mediant 3000
Document #: LTRT-89730