Tools Required To Install The Tx Matrix Plus Router; Step 2: Install The Mounting Hardware For A Tx Matrix Plus Router - Juniper TX Matrix Plus Quick Start Manual

TX Matrix Plus Router Quick Start

Tools Required to Install the TX Matrix Plus Router

Step 2: Install the Mounting Hardware for a TX Matrix Plus Router

4
For service personnel to remove and install hardware components, there must be
adequate space at the front and back of the TX Matrix Plus router. Allow at least 30 in.
(61.0 cm) both in front of and behind the TX Matrix Plus router.
The rack must have an adequate supply of cooling air.
Figure 1: Rack Clearances and TX Matrix Plus Platform Dimensions
30" (72.6 cm)
clearance recommended
for maintenance
Front of chassis
23"
(58.4 cm)
(mounting hole width)
Front
cable manager
depth 2.7" (6.9 cm)
A mechanical lift (required)
7/16-in. nut driver
1/2-in.or 13 mm open-end or socket wrench for removing chassis from pallet
Phillips (+) screwdriver, number 2
Electrostatic discharge wrist strap
Antistatic mat
Dust-free resealable plastic bags for temporary storage of fiber-optic dust covers
Electrostatic discharge (ESD) grounding wrist strap
Blank panels to cover any slots not occupied by a component
You can install the mounting hardware in either an open-frame rack or a four-post rack.
Install the TX Matrix Plus Mounting Hardware for a Four-Post Rack on page 5
Install the TX Matrix Plus Mounting Hardware for an Open-Frame Rack on page 8
36.2" (91.9 cm)
Center-mounting bracket
Front-mounting flange
Copyright © 2015, Juniper Networks, Inc.
Cable
management
depth 9"
30" (61 cm)
clearance required
for maintenance
Rear of chassis
21.4"
(54.4 cm)