Mounting The Ln2600 Router On The Wall - Juniper LN2600 Hardware Manual

Rugged security router

Hide thumbs Also See for LN2600:

Table of Contents

LN2600 Rugged Security Router Hardware Guide

Mounting the LN2600 Router on the Wall

Diagnostic Tests on page 40

You can mount the LN2600 router on the wall with the help of a wall-mounting kit. The

wall-mounting kit comes with heat sink unit that provides enhanced cooling to the

LN2600 router.

NOTE:

The wall on which you want to install the LN2600 router along with

the wall-mounting unit must have the following:

The thickness of the wall must be a minimum of 1 meter to allow easy

access to the connectors.

If you are installing the LN2600 router wall-mounting unit on a plywood

wall, the thickness of the plywood wall must be a minimum of 3/4 inch.

The concrete wall must be a minimum of 800 PSI (5.5 MPA) strength.

Ensure that you have the following parts and tools available:

Phillips (+) screwdriver with a minimum shaft length of 6 inches (150 mm)

3/8 inches ratchet driver set

An electrostatic discharge (ESD) grounding strap

Wall-mounting unit along with the mounting screws and chassis mounting screws

provided with the wall-mounting kit

Ground label and ground lug provided with the wall-mounting kit

Marker pen

Drilling machine

To mount the LN2600 router on the wall:

Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect

the strap to one of the ESD points on the chassis.

Prepare the LN2600 router for wall-mounting by removing the two screws and the

respective nuts located on the top and bottom center of the LN2600 router, and keep

the two screws for using it later. You may discard the two nuts. They are not required

for wall-mounting the LN2600 router.

Table of Contents