Table of Contents
Advertisement
IMPORTANT:
(by adding or removing hardware or operating system
software components), or repair the system, you must run the
Windows 2000 Update Module again.
Installing LAN Adapters
The following section includes special driver installation instructions for both LAN adapters used
in your system.
The drivers are initially installed during the installation of Windows 2000 and upgraded when you
run the "Windows 2000 Update Module", see "Installing Microsoft Windows
System" found earlier in this appendix. Use the following procedure to manually configure the link
speed and duplex mode.
We recommend you add "Network Monitor" at "Add/Remove
NOTE
:
Programs".
"Network Monitor" can monitor frames (or packets) sent or received by a
computer on which "Network Monitor" is installed. This is an effective tool
for analyzing network faults.
For information about the installation procedure, see Chapter 4.
Double-click the [Intel(R) PROSet II] icon on the [Control Panel] window.
1.
Select [Intel(R) 82546EB Based Dual Port Network Connection] in the list.
2.
Click [Link Config] and specify the link speed and duplex values (same values as specified
3.
for HUB).
Select [Intel(R) 82546EB Based Dual Port Network Connection #2] in the list.
4.
Click [Link Config] tab and specify the Link Speed & Duplex values (same values as
5.
specified for HUB).
Also, add/delete any protocols and services if necessary.
You can operate the process from [Network and Dial-up Connection] to display the property
dialogue box for local area network.
If you change the configuration of the system
Installing Windows 2000 C-5
®
2000 Operating
Advertisement
Table of Contents
