Table of Contents
Advertisement
Use this procedure to install a RAID controller board.
Install the RAID controller board into any PCI slot on the system board. See Installing an
1.
Option Board earlier in this chapter.
Cable the RAID controller board as described below:
2.
Remove the end of the SCSI interface cable that is plugged into the Ultra 320 SCSI hard
!
disk drive bay connector (SCSI A) on the system board.
Reinstall the end of the SCSI interface cable just removed into the Channel 0 connector on
!
the RAID board.
Disk array controller board
Install one end of the RAID controller LED cable into the LED cable connector on the
3.
RAID controller board and the other end of the cable into the LED cable connector on the
system board.
This enables you to check the access status of the disk array controller board with the disk
access LED on the front face of the server.
Ultra 320(A) SCSI connector for
connecting hard disks
SCSI cable
SCSI cable
Upgrading your Server 7-35
Ultra 320(B) SCSI connector
for connecting 5.25-inch
device bay
Advertisement
Table of Contents
