2-22 Setting Up Your System
Make sure that the frame at the bottom of the front cover is inserted
NOTE:
into the groove of the screw plate.
Tighten both thumbscrews.
3.
Installing the Top Cover
Follow the procedure below to install the top cover.
Place the cover so that the tabs go into the slots on the server. The cover should be inserted
1.
flush against the chassis.
Slide the cover forward until it stops.
2.
Tighten the two captive screws into the rear of the chassis.
3.
Tighten the screw you removed earlier on the rear of the chassis.
4.
Insertion slot
Tab
Front cover
Top cover