Installing Lan Adapters; Driver Installation For The Intel Pro/100+ Lan Adapter; Driver Installation For The Ati Rage Xl Display Adapter - NEC Express5800 User Manual

9. Insert the EXPRESSBUILDER CD into the CDROM drive. The START menu
displays.
10. Select "Drivers and Utilities" from the START menu.
11. Select 120Ee.
12. Select and run the "Windows 2000 NEC Update Module" for the Express5800
120Ee Server.
Note:
or removing hardware or operating system software components), or
repair the system, you must run the Windows 2000 NEC Update
Module again.

Installing LAN Adapters

The following section includes special driver installation instructions for the Intel
PRO/100+ LAN adapter used in your system.

Driver Installation for the Intel PRO/100+ LAN Adapter

The PRO/100+ driver is initially installed during the installation of Windows 2000 and
upgraded when you run the "Windows 2000 NEC Update Module, see "Installing
Microsoft Windows
to utilize the PRO/100+ LAN adapter "teaming features," diagnostic features, or
detailed adapter information, use the following procedure to install "PROSET II for
Windows 2000."
1. Power on, start Windows 2000, and log on.
2. Insert the EXPRESSBUILDER CD into the CDROM drive. The "Start" Menu
displays.
3. Select "Drivers & Utilities" from the "Start" Menu.
4. Select INTEL.
5. Select and run "PROSET II for Windows 2000."

Driver Installation for the ATI RAGE XL Display Adapter

To take full advantage of the on-board ATI RAGE XL display adapter, perform the
following driver installation procedure:
1. Power on, start Windows 2000, and log on.
2. Insert the EXPRESSBUILDER CD into the CDROM drive. The "Start" Menu
displays.
3. Select "Drivers & Utilities" from the "Start" Menu.
4. Select ATI.
5. Select and run "Rage XL Driver for Windows 2000."
C-6 Installing and Configuring Windows 2000 and Windows NT 4.0
If you change the configuration of the system (by adding
®
2000 Operating System" found earlier in this appendix. In order