Table of Contents
Advertisement
Submenu item
Sync Transfer Rate
(MB/Sec)
Packetized
QAS
Initiate Wide
Negotiation
Enable Disconnection
Send Start Unit
Command
BIOS Multiple LUN
Support
Include in BIOS Scan
Advanced Configuration
!
Move the cursor onto "Advanced Configuration" and press Enter to display the following
submenu.
Reset SCSI Bus at IC Initialization ............................................................ Enabled
Display <Ctrl><A> Message During BIOS Initialization .............................. Enabled
Extended Int 13 Translation for DOS Drives > 1 GByte.............................. Enabled
POST Display Mode .................................................................................. Diagnostic
SCSI Controller Int 13 Support
Options Listed Below Have NO EFFECT if Int 13 Support Is Disabled
Domain Validation .................................................................................... Enabled
Support Removable Disks Under Int 13 as Fixed Disks ............................. Disabled
BIOS Support for Bootable CD-ROM ......................................................... Enabled
Parameter
Description
[320]
33.3
Select [320] as recommended.
You may need to change the value depending
160
20.0
on your optional device.
80.0
10.0
Refer to the manual that comes with your
66.6
ASYN
optional device.
40.0
Optimizes bus utilization and minimizes
[Yes]
command overhead to bolster performance
No
by transferring commands, data, and status
using Dual Transition (DT) data phases.
Yes
Quick Arbitration and Selection (QAS)
reduces the overhead of control release on
[No]
the SCSI bus from one device to another to
help decrease command overhead and
increase bus utilization.
[Yes]
Select "Yes" if your SCSI device supports the
Wide SCSI interface. Select "No" if not.
No
[Yes]
Select "Yes".
No
[Yes]
Select "Yes" to send the command to the hard
disk. Otherwise select "No".
No
Yes
Select "No".
[No]
[Yes]
Select "Yes".
No
Advanced Configuration
Configuring Your System 3-37
[
]: Factory-set
Enabled
Advertisement
Table of Contents
