Table of Contents
Advertisement
RECOVERY FOR Windows 2000 SYSTEM
If any file necessary for running the OS is damaged, use the following procedures to recover the
system.
IMPORTANT:
After recovering the system, see "Updating the System" in Chapter 4
!
and be sure to update the system.
Also on Windows 2000, you need to update all the drivers after the
system update. For more information, see "Installing and Configuring
Device Drivers" in Chapter 4.
If the hard disk cannot be recognized, you cannot recover the system.
!
Recovery Procedure - Windows 2000 -
Follow the procedure below and use the information contained in the disk to recover the system.
Turn on the power of the system.
1.
Insert Windows 2000 CD- ROM into the CD-ROM drive of your server.
2.
Press the RESET switch or press Ctrl, Alt, and Delete to reboot the server. (You may also
3.
turn off and then on again to reboot the server.)
<When no disk array controller is installed in the system>
4.
Proceed to step 8 according to the instructions on the screen.
<When LSI Logic MegaRAID 320-2 board is installed>
Press F6 while the message "Setup is inspecting your computer's hardware
configuration..." is displayed at the upper part of the screen.
Nothing is changed on the screen though F6 is pressed.
NOTE
:
Troubleshooting 6-33
Advertisement
Table of Contents
