Table of Contents
Advertisement
Click [Link Config] and specify the Speed value & Duplex value according to the value
5.
specified for HUB.
Click [OK] on the [Intel(R)PROSetII] dialog box.
6.
Also, add or delete any protocols and services as required. Perform these actions from the property
dialogue box of the local area connection under [Network and Dial-up Connection].
We recommend you add [Network Monitor] at [Add/Remove
NOTE:
Programs]. [Network Monitor] can monitor frames (or packets) that this
computer sends or receives. It is a valuable tool when analyzing network
trouble. For information on how to install the [Network Monitor], see the
section "Setup for Problem Resolution" later in this document.
Graphics Accelerator Driver
Update the installed standard Graphics Accelerator Driver.
If you want to utilize an optional Graphics Accelerator Driver board, follow the document provided
with the board to install the driver.
Insert the EXPRESSBUILDER CD-ROM into the CD-ROM drive.
1.
Click Start menu, point to [Programs], [Accessories] and click [Windows Explorer].
2.
Run "Setup.exe" in the following directory.
3.
<CD-ROM Drive Letter>:\WINNT\VIDEO\W2K\setup.exe.
Follow the messages to continue the installation.
4.
If the dialog message "Digital Signature could not been found." appears, select [Yes] to
continue.
Remove the EXPRESSBUILDER CD-ROM from the CD-ROM drive, follow the
5.
direction on the screen and restart the system.
Installing the Operating System and Utilities 4-13
Advertisement
Table of Contents
