Table of Contents
Advertisement
Error Code and Message
0232
Extended RAM
Failed at address
line
0250
System Battery is
Dead - Replace and
Run SETUP
0251
System CMOS
Checksum Bad -
Default
Configuration Used
0252
Password checksum
bad - Passwords
cleared
0260
System Timer Error
0270
Real Time Clock
Error
0271
Check date and time
setting
0281
Memory Size found
by POST differed
from EISA CMOS
02B0
Diskette drive A error Floppy disk A error.
02B1
Diskette drive B error Floppy disk B error.
02B2
Incorrect Drive A
type - run SETUP
02B3
Incorrect Drive B
type - run SETUP
02D0
System Cache error -
Cache disabled
02D1
System Memory
exceeds the CPU's
caching limit
POST Error Codes and Messages (continued)
Description
Extended RAM error.
No battery is available for the
system.
Checksum of system CMOS is not
correct.
The passwords have been
cleared.
System timer error.
Real-time clock error.
Real-time clock is set incorrectly.
Memory size error.
The type of drive A is incorrect.
The type of drive B is incorrect.
System cache error - Cache
disabled. The cache cannot be
used.
System Memory exceeds the
CPU's caching limit.
Troubleshooting 6-5
Action
Contact your service
representative to replace the
system board or DIMM board.
Contact your service
representative to replace the
battery. (After battery is
replaced, start the SETUP
utility to set required values
again.)
The default values were set.
Start the SETUP utility to set
required values again. If the
same error still occurs, call your
service representative.
Start the SETUP to provide
password settings again.
Start the SETUP utility and
select [Main] → [System Time]
and [System Date] to set the
correct time. If the same error
reoccurs, contact your service
representative.
Contact your service
representative.
Start the SETUP utility and
select [Main] → [Diskette A] to
set the required value again.
Check if the floppy drive cable is
correctly connected. If the error
persists, contact your service
representative to replace the
cable or floppy disk drive.
Start the SETUP utility to set
required values again. If the
error persists, contact your
service representative to
replace the cable and/or drive.
Contact
your
service
representative.
Advertisement
Table of Contents
