Table of Contents
Advertisement
The revision of the secondary processor may be different from the
NOTE:
one of the primary processor. This does not affect the system operation.
Installation
Install a CPU according to the following procedure.
See the section Preparing for Upgrade described earlier in this chapter.
1.
Remove the left-hand side access panel as described earlier in this chapter.
2.
Remove the top air duct as described earlier in this chapter.
3.
NOTE:
automatic processor termination. This means there is no need
to populate a terminator in an unused processor socket when
setting up a single processor system; however the processors
must be populated in the correct order for the system to power
on. Therefore, processor socket 1, which is located closest to
the board corner, located directly across from the memory,
must be populated first, before processor socket 2.
Lift the lever on the socket and remove the processor.
4.
Remove the new processor from its antistatic package and place it on a grounded,
5.
static-free surface or conductive foam pad.
Position the processor over the processor socket so that its pins align with the socket holes.
6.
NOTE
among four differ from others to prevent an incorrect insertion.
Confirm the pin mark and pin layout on the socket, and insert
the CPU correctly.
The Intel Xeon processor architecture provides
: Be aware of CPU direction. Pin layouts on two corners
Upgrading your Server 7-37
Retention
Advertisement
Table of Contents
