Table of Contents
Advertisement
Option
Parameter
Service Partition
–
Type
Assert NMI on
Disabled
PERR
[Enabled]
Assert NMI on
Disabled
SERR
[Enabled]
FRB-2 Policy
Disable FRB2 Timer
[Disable BSP]
Do not Disable BSP
Retry 3 Times
Boot Monitoring
[Disabled]
5 minutes
10 minutes
15 minutes
20 minutes
25 minutes
30 minutes
35 minutes
40 minutes
45 minutes
50 minutes
55 minutes
60 minutes
Boot Monitoring
[Retry 3 times]
Policy
Retry Service Boot
Always Reset
Thermal Sensor
Disabled
[Enabled]
BMC IRQ
Disabled
5
10
[11]
Post Error Pause
Disabled
[Enabled]
AC-LINK
Stay Off
[Last State]
Power On
The table below lists how selections for "AC-LINK" determine the power status of the server when
the power supply to the server restarts.
State before powered off
In service
Out of service (DC power: Off)
Forced shutdown *
* Pressing the POWER switch for at least four seconds shuts down the power to the server.
Description
Indicates the type of the service
partition.
Indicates whether PCI PERR is
supported or not.
Indicates whether PCI SERR is
supported or not.
Set this item to "Disable BSP."
Disables or enables the boot
monitoring feature. Set to disabled
when installing OS. Once OS is
installed, re-enable.
To use this function, install NEC
ESMPRO Agent. Do not use this
function if the system is booted
from the OS without installation of
NEC ESMPRO Agent or CD-ROM.
Set this item to "Disabled" if
ARCServe uses the Disaster
Recovery Option.
Indicates the policy when the timer
expired on booting.
Enables or disables temperature
sensor monitoring feature.
Sets the BMC IRQ.
Specifies whether the system waits
for user intervention on critical
POST errors or not.
Sets the AC-LINK feature.
Determines the mode of operation
if a power loss occurs. (See the
table below.)
Parameter
Stay Off
Last State
On
Off
Off
Off
Off
Off
Configuring Your System 3-25
Your Setting
[ ]: Factory-set
Power On
On
On
On
Advertisement
Table of Contents
