Table of Contents
Advertisement
3-8 Configuring Your System
Keyboard
To set Numlock
Select [Advanced] - [Numlock].
Security
To set passwords on the BIOS level
Select [Security] - [Set Supervisor Password] and enter a password.
Set Supervisor password first, then User password.
To enable/disable the POWER switch
Select [Security] - [Power Switch Inhibit] - [Enabled].
Select [Security] - [Power Switch Inhibit] - [Disabled].
IMPORTANT:
Chapter 6) as well as power on/off using the POWER switch.
To set the secure mode
Select [Security] - [Secure Mode] and set each item.
External Devices
To set up external devices
Select [Advanced] - [I/O Device Configuration] and set up each device.
Internal Devices
To set up internal PCI devices of the server
Select [Advanced] - [Advanced Chipset Control] - [PCI Device] and set up each device.
To install the disk array controller board or graphics accelerator board
Select [Advanced] - [PCI Configuration] - [PCI Slot n] - [Option ROM Scan] - [Enabled].
n: slot number
To clear the hardware configuration data (after installing/removing internal devices)
Select [Advanced] - [Reset Configuration Data] - [Yes].
Masking the POWER switch disables forced shutdown (see
Advertisement
Table of Contents
