Table of Contents
Advertisement
RELOCATING/STORING THE SERVER
Follow the procedure below to relocate or store the server:
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injury, or property damage.
Never attempt to lift the server only by yourself. Make sure you have two
persons assisting you.
Do not install the server in any place other than specified.
Do not connect/disconnect any interface cable with the power cord of the
server plugged to a power source.
IMPORTANT:
If the server needs to be relocated/stored due to a change in the floor
!
layout to a great extent, contact the sales agent.
Make sure to make a backup copy of your valuable data in the hard disk,
!
if any.
Make sure not to apply a shock to hard disks when relocating the server
!
if it contains any.
Take a floppy disk and a CD-ROM out of the server, if any.
1.
Power off the server (the POWER/SLEEP lamp goes off).
2.
Unplug the power cord of the server from a power outlet.
3.
Remove all the cables from the server.
4.
Hold the server by its bottom with at least three persons to carry the server.
5.
IMPORTANT:
front door may be disengaged from the server, causing personal
injury.
Protect the server with the shock-absorbing materials, and pack it securely.
6.
CAUTION
Do not hold the front door to lift the server. The
Maintenance 5-11
Advertisement
Table of Contents
