Table of Contents
Advertisement
Starting and Ending the System Diagnostics
There are two ways to diagnose the server: to use the local console (keyboard) of the server itself,
and to use the management PC via serial port (remote console).
Procedures to start the diagnostic program is as follows:
IMPORTANT:
both LAN and COM ports can be used in remote console mode, however,
in system diagnostics, only the COM port can be used.
Shutdown the OS, and turn off the server. Then, unplug the power cord.
1.
Disconnect all the LAN cables from the server.
2.
Plug the power cord and turn on the server.
3.
Use the EXPRESSBUILDER CD-ROM to reboot the server.
4.
See the electronic EXPRESSBUILDER User's Guide for details.
The following menu appears when starting the server using the EXPRESSBUILDER.
Select [Tools].
5.
Select [System Diagnostics].
6.
The system diagnostics starts and completes in approximately three minutes.
When the diagnosis completes, the following appears on the screen of the display unit.
In the EXPRESSBUILDER User's Guide, you will find that
Local console
Maintenance 5-9
Remote console
Advertisement
Table of Contents
