Starting
The following two methods are available to start the server.
Running EXPRESSBUILDER from the management PC via LAN
!
Running EXPRESSBUILDER from the management PC via direct connection (COM B)
!
For the MWA installation and setup methods below, see "MWA" described earlier.
IMPORTANT:
Do not change the boot device order in BOOT menu in BIOS SETUP.
!
EXPRESSBUILDER cannot be used if the CD-ROM drive is not the
first device to launch the system.
To use this feature, you need a 3.5-inch floppy disk. Please prepare the
!
floppy disk.
The following items of BIOS setup information will be set as
NOTE:
shown below.
LAN Controller 1:
!
Serial Port A:
!
Base I/O Address:
Interrupt:
Serial Port B:
!
Base I/O Address:
Interrupt:
BIOS Redirection Port:
!
Baud Rate:
!
Flow Control:
!
Console Type:
!
Installing the Operating System and Utilities 4-27
[Enabled]
[Enabled]
[3F8]
[IRQ 4]
[Enabled]
[2F8]
[IRQ 3]
[Serial Port B]
[19.2k]
[CTS/RTS]
[PC ANSI]