Table of Contents
Advertisement
2-2 Setting Up Your System
SETUP FLOW
Follow the flowchart below to set up the server.
Selecting the server site
Select a suitable site for the server.
Unpacking the system
Unpack the server and accessories from the shipping container
Connecting peripheral devices
Connect peripheral devices to the server.
Connecting the power cord
Connect the power cord to the server.
Turning on the server
Power on the server to start software setups. Setups depend on the optional internal
devices installed and the peripheral devices connected.
Installing the operating system
Install an operating system to the server. See Chapter 4.
Installing the utilities
Install the utilities from EXPRESSBUILDER CD-ROM.
Creating backup copies of system
After all the system setup procedures are completed, make backup copies of the
system.
System backup information is required for recovering the server if problems occur or
after replacing the system board.
Advertisement
Table of Contents
