Installation, Relocation, Storage, And Connection - NEC N8100-2189F User Manual

Precautions for Use (Be Sure to Read)

Installation, relocation, storage, and connection

CAUTION
Never attempt to lift the server by one person.
The server weights max. 18.5 kg (depending on its hardware configuration). Carrying the server by one
person may strain the back.
Securely hold the server by the base to move or lift. Do not attempt to lift it by holding the front bezel.
Doing so may cause the front bezel to come off, which may cause not only breakage of the server but also
cause the server to fall on to persons resulting in personal injury.
Do not install the server in any place other than specified.
Do not install the server in the following places or any place other than specified in this User's Guide.
Failure to follow this instruction may cause a fire.
 A dusty place
 A humid place such as near a boiler
 A place exposed to direct sunlight
 An unstable place
Do not use the server in an environment where corrosive gas is present
Do not install the server in a place subject to corrosive gases including sodium chloride, sulfur dioxide,
hydrogen sulfide, nitrogen dioxide, chlorine, ammonia, or ozone. Do not install the server in an
environment that contains dust, chemicals that accelerate corrosion such as NaCl or sulfur, or conductive
materials. Failure to follow this warning may cause the wiring on the printed wiring board to short-circuit,
leading to fire. If you have any questions, contact the store where you purchased the product or a
maintenance service company.
Do not connect or disconnect any interface cable with the power cord of the server plugged to a
power source.
Be sure to power off the server and unplug the all power cords from a power outlet before
installing/removing any optional internal device or connecting/disconnecting any interface cable to/from
the server. If the server is off-powered but its power cords is plugged to a power source, touching an
internal device, cable, or connector may cause an electric shock or a fire resulted from a short circuit.
Use only the specified interface cable.
Use only interface cables provided by NEC and locate a proper device and connector before connecting a
cable. Using an authorized cable or connecting a cable to an improper destination may cause a short
circuit, resulting in a fire.
Also, observe the following notes on using and connecting an interface cable.
 Do not use any damaged cable connector.
 Do not step on the cable.
 Do not place any object on the cable.
 Do not use the server with loose cable connections.
 Do not use any damaged cable.
19
Express5800/T110g-E User's Guide