Description On System Utility; Overview; Starting Setup Utility - NEC EXP805 User Manual

Chapter 3 Setup
2.

Description on System Utility

Here we describe System Utility. You need to fully understand the content and configure correctly.
2.1

Overview

System Utility is a utility to set up this device. This utility is installed in a flash memory in the server as standard
and can be run without requiring a media for boot.
Since the device is delivered with optimum set-up, in almost all cases no change is required. Use only when
the case applies to any of cases described in Chapter 3 (2.4 Cases that Require Configuration).
By using System Utility, wide variety of set-ups as follows become possible.

Configuration of the system device and options installed.

Enabling and disabling system functions

Display of system information

Selection of Primary Boot Controller

Configuration of Memory Option

Selection of language

Start of pre-boot environment such as built-in UEFI shell or EXPRESSBUILDER.
Regarding the details of System Utility, see Chapter 1 (1. System Utility) of Maintenance Guide (Common).
2.2

Starting SETUP Utility

Run POST following Chapter 3 (1.1.1 POST sequence).
After a while, the following message is displayed on the screen. (The on-screen message depends on your
environment.)
By pressing <F9> Key here, System Utility starts after POST is completed.
Furthermore, if an Admin Password has been set, a dialog box for password input will be displayed before
starting the system utility. Please enter the correct Admin Password.

Important Back up the system information beforehand to provide against an
unexpected failure or an update of System ROM.

After changing the settings of System Utilities, make sure to create a backup.
For details on how to create a backup, refer to "1. System Utilities" in
Chapter 1 of "Maintenance Guide (Common)".
Express5800/R120h-2M (2nd-Gen) User's Guide
2. Description on System Utility
229