Starting Setup Utility - NEC Bull NovaScale R620 User Manual

Starting SETUP Utility

Powering on the server starts POST (Power On Self-Test) and displays its check results. When our logo is displayed,
press Esc.
After a few seconds, either of the following messages appears at bottom left on the screen depending on your system
configuration.
Press <F2> to enter SETUP
Press <F2> to enter SETUP or Press <F12> to boot from Network
You may see either of the following messages at bottom left on the screen when POST terminates.
Press <F1> to resume, <F2> to SETUP
Press F2 to start the SETUP utility and display its Main menu.
If you have previously set a password with the SETUP utility, the password entry screen appears. Enter the password.
Enter password:[
Up to three password entries will be accepted. If you fail to enter the password correctly for three consecutive times, the
server halts. (You can no longer proceed.) Power off the server.
TIPS:
The server is provided with two levels of password: Supervisor and User. With the Supervisor password, you can
view and change all system configurations. With the User password, the system configurations you can view or
change are limited.
NovaScale R620 User Guide
]
4-3