Display - High End Systems SolaHyBeam 2000 User Manual

If you set a different address, each unit will start to "listen" to the channel number you have set, based on
the quantity of control channels of the unit. That means changing the settings of one channel will affect only
the selected device.
In the case of the led move head, which is a 39 channel fixture, you should set the starting address of the
first unit to 1, the second unit to 40(39 + 1), the third unit to 79 (39+ 40), and so on.

DISPLAY

The Display offers several features: you can set the starting address, run the pre-programmed program or
reset the device.
The main menu is accessed by pressing the -button until the display starts flashing. Browse through
the menu by pressing the -button, -button, -button or -button. Press the
Enter-button in order to select the desired menu. You can change the selection by pressing the
-button, -button, -button or -button. Confirm every selection by pressing the -button.
You can leave every mode by pressing the -button. After accessing the edit mode, the unit will
automatically exit to the main menu after 15 seconds from the last button press. When the unit is powered
on, if no data signal is connected after 1 minute, then the display will switch off automatically. The Display
does not need external power to operate. Hold down the -button for 3 seconds and the Display will
turn on by using the unit's battery built in battery.
23
SolaHyBeam 2000 User Manual v1.3