Heatsink - ABB ACS580-01 Hardware Manual

R Replacement
(R) Replacement in harsh conditions*
O Other work (commissioning, tests, measurements, etc.)
* Ambient temperature constantly over 40 °C, especially dusty or humid ambient conditions,
cyclic heavy load, or continuous nominal (full) load.
To maintain the best possible performance and reliability of the drive, inspect the drive
annually. Contact the service at least once in three years for replacement of aging
components.
Note: Recommended maintenance intervals and component replacements are based on
operation in specified ambient conditions.

Heatsink

The drive heatsink fins pick up dust from the cooling air. The drive runs into
overtemperature warnings and faults if the heatsink is not clean. When necessary,
clean the heatsink as follows.
WARNING! Obey the instructions in chapter
Ignoring the instructions can cause physical injury or death, or damage to the
equipment.
WARNING! Use a vacuum cleaner with antistatic hose and nozzle. Using a
normal vacuum cleaner creates static discharges which can damage circuit
boards.
1. Stop the drive and disconnect it from the power line. Wait for 5 minutes and then
make sure by measuring that there is no voltage. See section
electrical work
2. Remove the cooling fan(s). See section
3. Blow clean, dry and oil free compressed air from bottom to top and
simultaneously use a vacuum cleaner at the air outlet to trap the dust.
Note: If there is a risk of dust entering adjoining equipment, perform the cleaning
in another room.
4. Reinstall the cooling fan(s).
on page 16 before you start the work.
Maintenance and hardware diagnostics 121
Safety instructions
Fans on page 122.
on page 13.
Precautions before