External Control Connection Terminals, Frames R0 - ABB ACS580-01 Hardware Manual

32 Operation principle and hardware description

External control connection terminals, frames R0...R4
The layout of the external control connection terminals of the R0 frame is shown
below. Layout of the external control connection terminals is identical in frames
R0...R4 but the location of the control board with the terminals is different in frames
R3...R4.
R0...R4
S1
S2
X1
S3
X2
X3
X4
X5
X15
S5 S4
X10
1
2
3
X13
X8
X7
X6
X14
Description
X1 Analog inputs and outputs
X2 Aux. voltage output
X3 Programmable digital inputs
X4 Safe torque off connection
X5 Connection to embedded EIA-485
fieldbus adapter module (installed in
option slot 3)
X6 Relay output 3
X7 Relay output 2
X8 Relay output 1
X10 Auxiliary fan connection
X13 Option slot 1 (fieldbus adapter
modules)
X14 Option slot 2 (I/O extension
modules)
X15 Option slot 3 (embedded EIA-485
fieldbus adapter module)
S1, S2 Voltage/Current selection switches
for analog input 1 (S1) and analog
input 2 (S2), see section
on page 100.
S3 Voltage/Current selection switch for
analog output 1, see section
Switches on page 100.
S4, S5 Termination switch (S4), bias
resistor switch (S5), see section
Switches on page
1 Panel port (control panel
connection)
2 Cold configuration connection. This
connector is used with the CCA-01
configuration adapter.
3 Power OK and Fault LEDs. See
section LEDs
Switches
100
on page 130.