Electrical Power Network Specification; Voltage (U1); Motor Connection Data - ABB ACS580-01 Hardware Manual

Electrical power network specification

Voltage (U )
1
Network type
Rated conditional short-circuit
current (IEC 61439-1)
Frequency (f )
1
Imbalance
Fundamental power factor
(cos phi )
1

Motor connection data

Motor types
Voltage (U )
2
Short-circuit current protection
(UL 508C)
Frequency (f )
2
Frequency resolution
Current
Switching frequency
Input voltage range 3~ 380...480 V AC. This is indicated in
the type designation label as typical input voltage levels
3~ 400/480 V AC.
Public low voltage networks. TN (grounded), IT
(ungrounded) and corner-grounded TN systems. See
section Checking the compatibility with IT (ungrounded)
and corner-grounded TN systems
Note: Frame R4 cannot be used in corner-grounded TN
systems.
65 kA when protected by fuses given in the fuse tables
47 to 63 Hz. This is indicated in the type designation label
as typical input frequency level f
Max. ± 3% of nominal phase to phase input voltage
0.98 (at nominal load)
Asynchronous AC induction motors and permanent
magnet motors
0...U , 3-phase symmetrical, U
1
point. This is indicated in the type designation label as
output voltage level U2 (3~ 0...U1).
US and Canada: The drive is suitable for use on a circuit
capable of delivering not more than 100 kA symmetrical
amperes (rms) at 480 V maximum when protected by
fuses given in the fuse table.
0....500 Hz. This is indicated in the type designation label
as input frequency level f
0.01 Hz
See section Ratings
2 kHz, 4 kHz, 8 kHz, 12 kHz (depends on the frame and
parameter settings)
Technical data 149
on page 75.
(50/60 Hz).
1
at the field weakening
max
(0....500 Hz).
2
on page 134.