Electrical Installation; Contents Of This Chapter; Warnings; Required Tools - ABB ACS580-01 Hardware Manual
Hide thumbs
Also See for ACS580-01:
- Quick installation and setup manual (434 pages) ,
- Hardware manual (278 pages) ,
- Quick installation (276 pages)
Table of Contents
Advertisement
Electrical installation
Contents of this chapter
The chapter describes how to check the insulation of the assembly and the
compatibility with IT (ungrounded) and corner-grounded TN systems. It then shows
how to connect the power and control cables, install optional modules and connect a
PC.
Warnings
WARNING! Obey the instructions in chapter
you ignore them, injury or death, or damage to the equipment can occur.
Make sure that the drive is disconnected from the input power during
installation. If the drive is already connected to the input power, wait for
5 minutes after disconnecting the input power.
Required tools
To perform the electrical installation, you need the following tools:
• wire stripper
• screwdriver and/or wrench with a set of suitable bits.
Electrical installation 73
6
Safety instructions
on page 13. If
Advertisement
Table of Contents
