ABB ACS580-01 Hardware Manual page 26

26 Introduction to the manual
Term/abbreviation
Frame (size)
FSCA-01
I/O
IGBT
Intermediate circuit
Inverter
Macro
NETA-21
Network control
Parameter
PLC
PROFIBUS,
PROFIBUS DP,
PROFINET IO
PTC
R0, R1, ...
Rectifier
SIL
STO
Explanation
Refers to drive physical size, for example R0 and R1. The type
designation label attached to the drive shows the frame of the drive, see
section Type designation key
Optional EIA-485 adapter module
Input/Output
Insulated gate bipolar transistor
See DC link.
Converts direct current and voltage to alternating current and voltage.
Pre-defined default values of parameters in drive control program. Each
macro is intended for a specific application. See ACS580 firmware
manual (3AXD50000016097[English]).
Remote monitoring tool
With fieldbus protocols based on the Common Industrial Protocol
TM
(CIP ), such as DeviceNet and Ethernet/IP, denotes the control of the
drive using the Net Ctrl and Net Ref objects of the ODVA AC/DC Drive
Profile. For more information, see www.odva.org, and the following
manuals:
• FDNA-01 DeviceNet adapter module user's manual (3AFE68573360
[English]), and
• FENA-01/-11/-21 Ethernet adapter module user's manual
(3AUA0000093568 [English]).
User-adjustable operation instruction to the drive, or signal measured or
calculated by the drive
Programmable logic controller
Registered trademarks of PI - PROFIBUS & PROFINET International
Positive temperature coefficient (PTC) refers to materials that
experience an increase in electrical resistance when their temperature
is raised.
Frame (size)
Converts alternating current and voltage to direct current and voltage.
Safety integrity level. See chapter
Safe torque off. See chapter
on page 37.
Safe torque off function
Safe torque off function
on page 197.
on page 197.