ABB ACS580-01 Hardware Manual page 89

Electrical installation 89
3. Cut adequate holes into the rubber grommets. Slide the grommets onto the
cables. Prepare the ends of the cables as illustrated in the figure. If you use
aluminum cables, put grease to the peeled aluminum cable before connecting it to
the drive. Note: The bare shield will be grounded 360 degrees. Mark the pigtail
made from the shield as a PE conductor with yellow-and-green color. Slide the
cables through the holes of the lead-through plate and attach the grommets to the
holes (the motor cable to the right and the input power cable to the left).
3a
PE
3b
PE