Electrical Installation - ABB ACS580-01 Hardware Manual

Unpacking and checking the delivery
1. Open the option package.
2. Make sure that the package contains:
• CMOD-02 multifunction extension module
• mounting screw
3. Make sure that there are no signs of damage.
Installing the module
See chapter Installing option modules


Electrical installation

Warnings
WARNING! Obey the instructions in chapter
you ignore them, injury or death, or damage to the equipment can occur. If you
are not a qualified electrician, do not do electrical work.
Make sure that the drive is disconnected from the input power during
installation. If the drive is already connected to the input power, wait for
5 minutes after disconnecting the input power.
Necessary tools and instructions
• Screwdriver and a set of suitable bits
• Cabling tools
Terminal designations
For more detailed information on the connectors, see section
page 223.
Motor thermistor connection
Marking
60 PTC IN
61 PTC IN
Relay output
Marking
62 RO PTC C
63 RO PTC B
on page 110.
Description
PTC connection
Ground (earth) potential
Description
Common, C
Normally open, NO
Optional I/O extension modules 219
Safety instructions
Technical data
on page 13. If
on