Awd Front Drive Axle Installation - Polaris Trail Blazer Service Manual

Hide thumbs Also See for Trail Blazer:

Table of Contents

9. Remove cotter pin and nut from lower A-arm ball

joint. Remove lower A-arm from ball joint.

10. Using a drift punch remove roll pin at front housing.

11. Remove the spindle and axle assembly from the

strut casting bearing by pulling the strut outward as

shown. Drive out the old seal, taking care not to

damage the tapered roller bearing. Install the new

seal until it bottoms against the shoulder in the strut

AWD Front Drive Axle Installation

1. Install spring washer and drive shaft. Align hole in

U-joint yoke with hole in eccentric shaft, and install

new roll pin.

2. Install new seal in strut casting. Refer to page 7.10.

3. Install drive shaft in strut.

4. Install lower ball joint, torque nut to 25 ft. lbs. (3.45

kg-m) and install new cotter pin.

components and hub as outlined on page 7.7.

6. Tighten hub nut following procedure on 7.11.

Polaris Sales Inc.

AWD Front Drive Axle Removal/Installation